Brand: Maxwell Marine - NZ
Product Code: AWMHRC10SCWSD
Availability: In Stock
Ex Tax: NZ$2,500.38

Maxwell's all new HRC10 Horizontal Series represents yet another breakthrough in performance and anchor handling excellence. These horizontal, fully automatic rope/chain windlasses have been designed to meet the demands for use on larger vessels up to 16 metres (52 feet), which require a completely above deck installation system. The HRC10’s flawlessly handle rope up to 16mm (5/8") and chain up to 10mm (3/8") in size, including the thick rope to chain splice. The modern appearance of the HRC10 Series retains the classic good looks of previous Maxwell horizontal windlasses, while incorporating design features years ahead of its competitors.

This winch is the SCWSC Model meaning it has a single gypsy on one side and a single Castan on the other side.


  • The all new HRC10 fully automatic horizontal windlass series is designed to effortlessly retrieve and deploy 10mm (3/8”) short link chain and 16mm (5/8”) three strand or 8 braid rope.
  • The aesthetically pleasing above deck design, evolved from the philosophy of form follows function, encapsulates the motor and drive in a two part watertight case, saving space below deck.
  • The two part case consists of a die cast, marine-grade hard anodised alloy front section and a rugged and easily removable composite motor cover aft section.
  • This two piece watertight case allows for quick and easy, on-deck, routine maintenance.
  • Simple bolt down installation ensures effortless and rapid on-deck installation and set up.
  • The stainless steel pressure arm always exerts maximum control pressure on the rode (rope, splice or chain).
  • The new and revolutionary patented Wave Design™ chainwheel is able to accommodate a wide range of chain pitch differences, within the specified chain size diameters, suitable for use with the HRC10 Series.
  • The unique Maxwell wrap around™ horizontal chainwheel ensures that more than 90° of the wheel is used, allowing greatly improved rope and chain handling compared with competitor designs.
  • The HRC10 works just as effectively with all-chain rodes for those who desire the added security and holding power of an all-chain anchor system.
  • The integral chain pipe and huge, through deck hawse pipe throat ensures easy entry of the rope/chain rode into and out of the anchor locker.
  • Cone type clutch/brake mechanism permits manual, free fall™ anchoring and emergency crank recovery of the rode and anchor if required.
  • The sealed oil bath and marine-grade hard anodised, alloy gearbox provides high efficiency output drive via precision worm and wormwheel.


Model HRC10-10
Maximum pull 850kg - 1870lb
Static hold 1500kg - 3300lb
Max recommened rope size 16mm 8 Braid or a high quality 3 strand
Chain size 10mm (higher the quality all the better for longevity)
Power 12V 1200W
Weight 13kg - 28.5lb
Chain Speed at nominal working load 24m/min - 79ft/min
Rope Speed at nominal working load 20m/min - 66ft/min
Supplied with the winch Dual direction solenoid pack
Optional Extras

Up/down remote control panel
Circuit breaker/isolator panel


A 369mm
B 199mm
C1 316mm
C2 225mm
D 80mm
E (std deck clearance) 90mm
F 92mm
G 110mm
H 80mm
J 99mm
C3 140mm


Write a review

Please login or register to review